Instructions for Making Beaded Floral Bracelet

BEADED FLORAL

BRACELET

YOU WILL NEED: A cutter, a plier, a jump ring, a clasp, 0.3 color-coated tigertail wire, 8 x 3mm metal beads, 16 x 2mm metal beads, 49 x 4/8mm rice-shaped glass beads, 64 x 4mm

diamond fire polish glass beads.

Cut wire of approximately 80 inches.

Thread 2 x 3mm metal beads, a clasp, 2 x 3mm metal beads onto the middle of the wire. Thread both wires in opposite directions through a glass bead. Pull the wire gently.

Thread 1 glass bead onto each side of the wire. Thread both wires in opposite directions through another glass bead. Pull the wire gently.

Thread 1 glass bead onto each side of the wire again. Thread both wires in opposite directions through another glass bead. Pull the wire gently. Repeat these steps 14 times.

Thread 2 x 3mm metal beads, a jump ring, 2 x 3mm metal beads onto one side of the wire. Thread both wires in opposite directions through the beads you have just threaded onto the

wire. Thread both wires in opposite directions through a glass bead. Pull the wire gently.

 

 

Thread 1 fire polish glass bead onto each side of the wire. Thread both wires in opposite directions through 1 x 2mm metal bead. Thread 1 fire polish glass bead onto each side of the

wire again. Thread both wires in opposite directions through the glass bead opposite the glass bead through which the wires were just threaded; this makes a flower.

Continue until you have a bracelet of flowers long enough to reach the other side of the bracelet. Run the excess wire through all the glass beads until the one side meets the other side.

Tie them together well. Cut off the excess wire.
 
   
   
   

 

 
   
   
   
 

.

   
   
   
   
   
   
   
   

 

wabusiness template