Instructions for Making Beaded Swarovski Square Pendant Necklace

BEADED SWAROVSKI SQUARE PENDANT NECKLACE

YOU WILL NEED: A cutter, a clasp, 16 crimp beads, 2 jump rings, wire 0.25, color-coated tigertail wire, 49 x 4mm turquoise Swarovski crystal beads, 48 x 4mm khaki Swarovski crystal beads, 10 x 5mm turquoise Swarovski crystal beads.

Cut 1 piece of 0.25 wire of approximately 40 inches. Thread 9 x 4mm turquoise beads onto the wire.

Thread 1 turquoise bead, 7 khaki beads, 1 turquoise bead on one side of the wire. Connect this side with the other side by threading the wire through the last bead.

Thread 1 turquoise bead, 3 khaki beads, 1 turquoise bead, 3 khaki beads, 1 turquoise bead on one side of the wire. Connect this side with the other side by threading the wire through the last bead.

Repeat these steps according to the pattern. Note that there is a diamond shape inside the square pendant.

Cut a piece of color-coated tigertail wire of approximately 16 inches. Thread this wire through the top layer of turquoise beads of the square pendant.

Thread a crimp bead on both the 0.25 wire and the color-coated tigertail wire. Squeeze the crimp bead close to the beads. Cut off the excess 0.25 wire. Repeat these steps on the other side of the square pendant.

Thread a crimp bead about 1 inch away from the square pendant. Squeeze the crimp bead. Thread 1 khaki bead, 1 x 5mm turquoise bead, 1 khaki bead and 1 crimp bead. Squeeze the crimp bead.

Thread a crimp bead about 1 inch away again. Squeeze the crimp bead. Thread 1 x 4mm turquoise bead, 1 khaki bead, 1 x 5mm turquoise bead, 1 khaki bead, 1 x 4mm turquoise bead and 1 crimp bead. Squeeze the crimp bead.

Thread a crimp bead about 1 inch away again. Squeeze the crimp bead. Thread 1 x 5mm turquoise bead, 1 khaki bead, 1 x 5mm turquoise bead, 1 khaki bead, 1 x 5mm turquoise bead and 1 crimp bead. Squeeze the crimp bead.

Repeat number 7 to 9 on the other side of the wire.

Thread a bead cap and a crimp bead at the end of the wire. Squeeze the crimp bead at the end. Cover the crimp bead with the bead cap. Fold the loop on the bead cap over. Repeat these steps on the other side of the wire.

Attach a jump ring to the loop of the bead caps on both sides.

Attach a clasp to the jump ring on one side.