Instructions for Making Beaded Bracelet/Necklace/Earrings Set

MATCHING BEADED BRACELET,

YOU WILL NEED: A straight -nosed plier, a round-nosed plier, a cutter, brown coated tigertail wire, 2 toggle clasps, 7 jump rings, 2 earring hooks, 6 posts, 4 inches of link

THE BRACELET: Cut 1 piece of wire of approximately 12 inches.

Thread a bead cap and a crimp bead onto the wire. Squeeze the crimp bead at the end of the wire. Cover the crimp bead with the bead cap. Fold the loop on the bead cap over.

Thread 9 glass pearl beads and 8 beige gold luster glass beads alternately onto the wire. Begin with the glass pearl bead.

Thread a bead cap and a crimp bead onto the wire. Squeeze the crimp bead close to the beads. Cover the crimp bead with the bead cap. Fold the loop on the bead cap over.

Cut the excess wire.

Attach a jump ring to the loop of the bead cap. Attach the other side of the toggle clasp to the jump ring.

THE BRACELET DECORATION: POST A: Thread 1 glass pearl bead, 1 small gold bead and 1 glass pearl bead onto a post. Attach a chain of 7 links to the folded end of the post.

POST B: Thread 1 glass pearl bead and 1 beige gold luster glass bead onto a post. Attach a chain of 10 links to the folded end of the post.

Attach POSTS A and B to the jump ring which is attached to the toggle clasp.

THE NECKLACE: This is made in the same way as the bracelet, only the wire is approximately 20 inches. Thread 25 glass pearl beads and 24 beige gold luster glass beads. The

THE EARRINGS: POST A: Thread a glass pearl bead and a beige gold luster glass bead onto the post. Fold up the end of the post.

POST B: Thread 3 glass pearl beads and 2 small gold beads alternately onto another post. Fold up both ends of the post. Join POST A and POST B with a jump ring. Attach an

Repeat these steps to make a second earring.